Hi all!
I tried to make a simple design based on the LM723 datasheet, without sucess so far, because I have almost no knowledge in electronics projeting.
I would like to make it voltage-dropouts-proof, with a PNP pass transistor and also to try to use as few components as possible.
I've attached a image of the circuit. Any suggestions are welcome!
VIN: 19VDC
VOUT: 14,4VDC
Thanks for the attention and best regards!
I tried to make a simple design based on the LM723 datasheet, without sucess so far, because I have almost no knowledge in electronics projeting.
I would like to make it voltage-dropouts-proof, with a PNP pass transistor and also to try to use as few components as possible.
I've attached a image of the circuit. Any suggestions are welcome!
VIN: 19VDC
VOUT: 14,4VDC
Thanks for the attention and best regards!
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.