Hi all,
What does you think of this http://peufeu.free.fr/audio/alim_mos_diode/
Would this work to reduce a trafo with a slightly higher voltage than what I require? Does anybody know the formula for calculating what drop in voltage this Mosfet usage will give? Is it only for low current usage & not suitable for power amp?
I want to use it on Greg Balls' SKA GB150D power amplifier using a trafo which has 32-0-32 output & combine both outputs to give about 55V DC after rectification - can this be done?
John
What does you think of this http://peufeu.free.fr/audio/alim_mos_diode/
Would this work to reduce a trafo with a slightly higher voltage than what I require? Does anybody know the formula for calculating what drop in voltage this Mosfet usage will give? Is it only for low current usage & not suitable for power amp?
I want to use it on Greg Balls' SKA GB150D power amplifier using a trafo which has 32-0-32 output & combine both outputs to give about 55V DC after rectification - can this be done?
John
Yes, the circuit shown will drop almost 10V DC under heavy load and 6V DC or so under light load. Note that a center tapped transformer arrangement producing symmetric voltage rails would drop half the voltage in ecah rail. Concerning the body diodes, they are not used at all, furthermore, conventional diodes wired in series are required in order to bypass them as the schematic shows.
Yes, you get a diode that way, but it's not fast recovery at all. The body diode of a conventional MOSFET behaves much like a (damn expensive) standard recovery diode 
Only some latest generation MOSFETs feature fast recovery body diodes (always at the expense of higher Rds-on), and they are really expensive.
Only some latest generation MOSFETs feature fast recovery body diodes (always at the expense of higher Rds-on), and they are really expensive.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.