|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
19th August 2005, 02:12 PM
|
#1 |
|
diyAudio Member
Join Date: Jun 2005
Location: West London
|
adding caps and snubber network to LM3875 power board
Hi,
I was hoping someone could tell me if I have done this right please? I have made the caps and snubber section (less 1 cap) of the carlosfm power supply from here... http://myweb.tiscali.co.uk/nuukspot/...bberedPSU3.png And I want to put it between the power and amp boards of my rev3 LM3875 kit. As I'm connecting from the existing power board I have +V, 0 and -V, 0. I have connected the caps like this + to +V, and - to 0 and - to -V and + to 0. I'm pretty sure this is right because all I'm doing is running 2 seperate 0's but wanted to check as I don't fancy being anywhere near a 10,000 uF cap if it explodes! I have attached a pic, red is +V, black is -V and the 0's are white. |
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [SG3525 smps] Input capacitors puffing after adding snubber | aliazhar | Power Supplies | 36 | 21st November 2009 08:59 AM |
| Snubber network and the values | okina | Power Supplies | 9 | 22nd September 2009 11:12 PM |
| Snubber caps | atmars | Tubes / Valves | 2 | 15th November 2008 01:10 PM |
| New Snubber Board v.3 - Up in smoke | needlz | Chip Amps | 9 | 15th May 2005 05:46 AM |
| T network and supply snubber(?) revisited. | ashok | Chip Amps | 12 | 17th January 2005 08:37 AM |
| New To Site? | Need Help? |
| Page generated in 0.07013 seconds (100.00% PHP - 0% MySQL) with 10 queries |
