|29th April 2005, 03:18 PM||#11|
Join Date: Jul 2004
Location: Scottish Borders
I was asking about latching circuits.
I think it was someone else who offered the idea of a latching switch. I have not followed that up.
There was a thread recently about wiring switch on relays to give a latch on and auto latch off from a push to make switch. Its not current but ran about 5 or 6 weeks ago.
regards Andrew T.
Sent from my desktop computer using a keyboard
|2nd May 2005, 09:15 PM||#12|
Join Date: Sep 2003
Location: Alps:Tube amp designs over 150W, SMPS guru.
Need to differentiate between <brown outs> and near <power outages>..both require different circuit analogies. Timing wise... most electronic gear has enough CV hold-up to accept brown outs, but a total loss i.e we all know what happens to computers.
If a brown out preceeds the power failure,i.e large AC volts dip the equipment volts may still hold up before undervoltage flag shows....Most dangerous is an intermittent supply failure which may suddenly reapply full AC supply. I get alot of this up here when thunderstorms are around. A fast 20ms breaker breaker can be annoying, but it isn't when a high VA transformer is connected.
The subject of under voltage; overvoltage; and other various protection is important to reliability.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Soft Start Necessary?||dtaylo3||Class D||2||26th December 2008 10:05 AM|
|B+ soft start||Gluca||Tubes / Valves||2||3rd September 2007 02:04 PM|
|Need a soft start?||maxpou||Solid State||19||18th April 2007 10:23 PM|
|Soft start & Soft Switch circuit: can anybody help?||m.parigi||Solid State||95||22nd August 2005 04:32 PM|
|New To Site?||Need Help?|