Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|27th October 2015, 07:18 AM||#1|
Join Date: Sep 2014
Luxman RV-357 Standby LED Indicator???
I got a problem on Luxman AV Surround Sound AM/FM Receiver RV-357.
There was no Standby LED indicator shown when I powered up the set.
As a result of the above, I tried to investigate the root cause of it....
Below here were findings, checking physically on Power Board RV-357-9 :-
- Presence of Main AC Power Supply
- No blown fuse (Location F1, 3.15A)
- No blown ICP fuse (Location IC552, ICP-N-15)
- Presence of 6.0 VDC at pin 3 of voltage regulator 7806A (Location IC551), but there's still no presence of Standby LED indicator shown on the front panel. I could not progress anymore from here....
I would appreciate it if anyone of you could enlighten me.
Should you have RV-357 schematic, kindly share it with me.
Thanking you in advance.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Luxman Av Receiver Rv-357||elec972||Solid State||1||26th October 2015 04:37 PM|
|Luxman RV 371 Speaker Switch||preetham||Solid State||1||9th September 2015 08:43 AM|
|Luxman A-357 schematic||Pacorl||Solid State||4||13th January 2011 09:26 PM|
|LED source indicator||snails07||Chip Amps||5||19th August 2008 11:24 AM|
|LED bias indicator||scottw||Tubes / Valves||6||6th December 2007 12:19 PM|
|New To Site?||Need Help?|