Tranny hookup

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Secondary hooked up as Primary to match channels.

Transformer is hooked up with:
Red wire and a black wire in parallel
Green wire and brown wire in parallel
When measured it's at 1.9ohm and gives a Higher voltage.
however there are two orange wires that measure 1.8ohm just like the "matching" transformer I'm trying to well match it to. (one is factory replacement but doesn't seem to match well enough for me)

I think maybe one is Chinese 110v vs an American 120V.

So anyway the one Transformer with the 2 paralleled primary's measuring 1.9ohms also has 2 orange wires of the same guage that measure 1.8ohm like the primary's on the other transformer.

Should I hook them up and see if that matches the two channels power supplies?
 
Last edited:
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.