That's the proper line, even on real active circuit load.
What was the vertical (volt/div) knob's position George?
Didn' t notice, because I put the scope on AC. The line on the scope doesn' t change as I rotaded it though.
Supply voltage is 17V.
Last edited:
Transistors, Jfets, inspected for proper type proper place odd mistake too?
Yes old mosfets, JFETs inspected and are all OK in both regs.
Vgeorge and Salas: you're the only two Greeks not watching TV now I guess
I don' t know about Salas, but I forgot about the match!
Turned the TV on now!
Vgeorge and Salas: you're the only two Greeks not watching TV now I guess
We are off side.
Left channel negative rail with 100uF BG NP + Zobel 1R added
Try MKT.
Can't see the match in my scope.....
Remember to switch your TV on next Sunday around 6 pm then
Felipe, once I put a sk117 in the place of 560 and it worked, but had some issues, as far as I remember. Took me some time to figure out. So, please check for stupid mistakes like this.
FYI, I use 4,7uf MKT at the output
Thanks George, verified I have both 560 in place in both regulators.
Salas I change to 10uF MKT & check.
N.B. Final 1-1 & you failed a penalty but is a good result.
Remember to switch your TV on next Sunday around 6 pm then
Great match Italy vs Spain
Last edited:
What's different or wrong between your negative and George's smooth line negative? Any clear picture full length from above and under? Also picture of wires to dummy?Left channel with MKT
- Home
- Amplifiers
- Power Supplies
- SSLV1.1 builds & fairy tales