1st post....
Before I commit this simple cap/rectifier board to FRN, are there any obvious pitfalls? The layout is a compromise for size and aesthetics.
It will power two class AB boards (~50W into 8ohms x 2)
The bridge is a 35A KBU package (space for small heat-sink if required). The caps are 2200uF panasonic FMs.
Board is single sided, red are jumper wires.
Thanks!
Before I commit this simple cap/rectifier board to FRN, are there any obvious pitfalls? The layout is a compromise for size and aesthetics.
It will power two class AB boards (~50W into 8ohms x 2)
The bridge is a 35A KBU package (space for small heat-sink if required). The caps are 2200uF panasonic FMs.
Board is single sided, red are jumper wires.
Thanks!
An externally hosted image should be here but it was not working when we last tested it.
