I have a few questions about the use of current inrush limiting thermistors in a 120v amplifier power supply.
Is it helpful and worthwhile?
Where does the thermistor get added in the circuit?
Is a GE Sensing CL-60 adequate for an LM3886 project?
The datasheet from the vendor is here:
http://www.gesensing.com/downloads/datasheets/920_325a.pdf
Many thanks for any feedback, if I do this I want to be sure I do it safely.
Steve
Is it helpful and worthwhile?
Where does the thermistor get added in the circuit?
Is a GE Sensing CL-60 adequate for an LM3886 project?
The datasheet from the vendor is here:
http://www.gesensing.com/downloads/datasheets/920_325a.pdf
Many thanks for any feedback, if I do this I want to be sure I do it safely.
Steve