I recently acquired these BG in-wall planars:
http://www.radiapro.us/PDF/FullRangeDataSheet.pdf
I would like to run them as dipoles. They were in aluminum enclosures filled with fiberglass. There is foam on the back side of the driver - see pic below. Should I remove the foam to run them as dipoles?
Thanks,
Bruce
http://www.radiapro.us/PDF/FullRangeDataSheet.pdf
I would like to run them as dipoles. They were in aluminum enclosures filled with fiberglass. There is foam on the back side of the driver - see pic below. Should I remove the foam to run them as dipoles?
Thanks,
Bruce
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.