rd75 and cxr22

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
V

v12nut

Member
Joined 2013
Hi all,
I have just taken my RD75s out of storage (been wrapped up for over 8 years:-(
I also have a Clearview CXR22 Xover for use with these speakers, problem is I have lost the idiots guide! Can anyone tell me if this xover has the B&G recommended 'notch filter' built in or do I still need to fit that inline from the xover to the ribbon?

If anyone has the xover instructions I would really appreciate a copy.

Cheers

Tom
 
K

kcollins

Member
Joined 2005
Hello Tom,

I hope you find the attached documents of use.

regards,

Keith
 

Attachments

  • Clearview CXR-22 Manual Part 1.pdf
    865.6 KB · Views: 127
  • Clearview CXR-22 Manual Part 2.pdf
    888.1 KB · Views: 86
  • Audio X Stream Site.pdf
    117.8 KB · Views: 109
  • Clearview CXR-22 Response.pdf
    220.4 KB · Views: 100
A

audiomagnate

Member
Joined 2011
v12nut said:
I have a few woofer choices available to me and to be honest 400Hz is a bit high but to be able to vary between 150 to say 350Hz with just a few component changes would be good, but knowing which components is the question.
cheers
Click to expand...

It takes me literally a second or two to make that change. I use a DCX2496. I have a line array of six Monsoons that acts a bit like the RD75. I've settled on 240 Hz after lots of listening and measurement.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom