Allegro PCB Editor

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Hi!

Sorry for this attempt, but i don't know where else to go.
I've tried on the different forum on Cadence-orcad.
I have the following issue:

I would like to transport the board (amplifier) that i have designed with orcad Capture CIS 10.5 to Allegro PCB Editor 620.

The problem is that i don't find any valid footprint information to associate to the different components on the schematic.
The result is that when i open Editor with the imported data, it's just a black board without component (the warning message is that it cannot find the specified PCB footprint chosen).

Hope somebody can help me out and tell me what to do.


Sorry again to bug you with this 3d.


Hope to receive good advice.


Best,
Stefano.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.