Today I finally could test my BoSoZ and get to listen to it. Unfortunately I've made something wrong, 'cause I measure 118 volt on drain of Q1 and Q2, where it should have been +30 volts. When turned on the amp plays (very quietly) for 10 sec and then fades out.
PSU works fine and I get 60 volt.
My amp is unbalanced only and I use 10K pots at P1 and zeners at input.
Any hints? Maybe I was not handling my FETS with care when I soldered them in on the board....
PSU works fine and I get 60 volt.
My amp is unbalanced only and I use 10K pots at P1 and zeners at input.
Any hints? Maybe I was not handling my FETS with care when I soldered them in on the board....
This is my setup:
An externally hosted image should be here but it was not working when we last tested it.
Everything's OK now, yet right channel Q2 gets 35 v, while the other three FETS get about 30 v drain, but I guess this is within margin.
Forgot to connect ground from PSU to line. UPS x 1000.
Still have a lot to learn about electronics.
Thanks. Looking forward to listening to it.
Forgot to connect ground from PSU to line. UPS x 1000.
Still have a lot to learn about electronics.
Thanks. Looking forward to listening to it.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- BosoZ - damaged FETS ?