Aleph3 bridged?
 

Is it possible?
i want to get it support xlr
will it distort much?

Build Aleph30.

i cannot build aleph30 since i cannot purchase pcbs from
http://web.vip.hr/pcb-design.vip/index.html
any way to convert 2 aleph3s into 1 aleph30?
or, any suggestions?

Patpet,

you can easily convert an Aleph3 to accept XLR. Just use the input scheme of an Aleph 30 or 60 (just two or three extra resistors).

William

Then purchase Aleph 5 boards and build with Aleph 30 components. Same thing. That's what I did. That's be a whole lot closer than taking two Aleph 3s and using them as one Aleph 30.

thx for replies
do a-30 and a-5 only differ in number of mosfets?

If you're going to the trouble to bridge Alephs, might as well build an Aleph-X.
The Volksamp versions of the Aleph circuit had slightly different front ends. Other than that, the differences between models were limited mainly to minor changes in resistor values to adjust the circuit for higher or lower rail voltages.

Grey