output Mosfet for Aleph2 - Page 2

AudioFreak · 15th April 2002, 01:06 AM

For the higher powered Alephs, I would strongly advise against using the 140 or 044 as the voltage rating is not sufficient to allow a satisfactory safety margin. Either 240's or 244's are fine for the job.

Cephas · 17th April 2002, 02:53 PM

so how about 250 compare with 240?

thanks.

AudioFreak · 17th April 2002, 03:13 PM

2 x 240's in parallel are better than 1 x 250

as has been said before, your best to stick to the schematic and use 240's or 244's either are fine

HarryHaller · 17th April 2002, 03:33 PM

How big of a heat sink would I need for that?

fcel · 17th April 2002, 03:46 PM

Harry: Another heatsink question for Aleph 2? Are you sure you're not a comedian?

17th April 2002, 03:33 PM	#14
HarryHaller Banned Join Date: Feb 2002 Location: Dallas,Texas	Aleph2 How big of a heat sink would I need for that?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Best MOSFET for output stages	millwood	Solid State	136	4th June 2010 07:54 AM
Mosfet output stage help (please)	bob123	Class D	5	3rd January 2006 11:48 PM
Aleph2 pcb's, matched fets for aleph2 and aleph ono pcb's	MemphisJim	Swap Meet	1	23rd September 2005 07:15 PM
What's the difference between original aleph2 and DIY aleph2?	chris910	Pass Labs	3	17th August 2003 09:03 PM
output mosfet driver	lazy	Solid State	5	30th March 2002 04:13 AM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read


	Please consider donating to help us continue to serve you. Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving

15th April 2002, 01:06 AM	#11
AudioFreak Warp Engineer On Holiday Join Date: Oct 2001 Location: Queensland, Australia	For the higher powered Alephs, I would strongly advise against using the 140 or 044 as the voltage rating is not sufficient to allow a satisfactory safety margin. Either 240's or 244's are fine for the job.

17th April 2002, 02:53 PM	#12
Cephas diyAudio Member Join Date: Apr 2002 Location: Hong Kong	so how about 250 compare with 240? thanks.

17th April 2002, 03:13 PM	#13
AudioFreak Warp Engineer On Holiday Join Date: Oct 2001 Location: Queensland, Australia	2 x 240's in parallel are better than 1 x 250 as has been said before, your best to stick to the schematic and use 240's or 244's either are fine

17th April 2002, 03:46 PM	#15
fcel diyAudio Member Join Date: Sep 2001 Location: LA County	Harry: Another heatsink question for Aleph 2? Are you sure you're not a comedian?

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)