i use two in parallel for 10W dissipation in my preamp and temp is fine
Ok. I will also try the mundorfs...
They should sound very natural, not??
In pre amp 10W disipation?
Thank you.
But I am very intrigued to use the caddock mp metal film,
they are non inductive in relation to wirewound...
these 40R 50W mills wirewound are not inductive too and sounds better ( to my ears)
just try both Mills are cheap and make your decision..
resistors_mills_mrc
why not just use some choke load ?
hammond have 200MH at 2amp or 1H at 1AMP
just try both Mills are cheap and make your decision..
resistors_mills_mrc
why not just use some choke load ?
hammond have 200MH at 2amp or 1H at 1AMP
Last edited:
A question here about the bias supply:
Would it be possible to use the bias supply schematic in http://www.audiohobby.com/pdf/lamp 193V.pdf but with an 18V trafo winding instead of the 15V in the schematic without modification or should some values be changed?
Would it be possible to use the bias supply schematic in http://www.audiohobby.com/pdf/lamp 193V.pdf but with an 18V trafo winding instead of the 15V in the schematic without modification or should some values be changed?
feel free to use 18Vac without any modification ; of course - voltage of first cap must be at least 35V
I hope you are not believing in everything written on the net
some ppl are way more dangerous than Tom Sawyer , when pursuing others to paint that fence
same as with heatsink - heatspreader can't be too big ......
feel free to use 18Vac without any modification ; of course - voltage of first cap must be at least 35V
I hope you are not believing in everything written on the net
some ppl are way more dangerous than Tom Sawyer , when pursuing others to paint that fence
same as with heatsink - heatspreader can't be too big ......
I do not...Thanks for careing.