Go Back   Home > Forums > >
Home Forums Rules Articles diyAudio Store Blogs Gallery Wiki Register Donations FAQ Calendar Search Today's Posts Mark Forums Read

Pass Labs This forum is dedicated to Pass Labs discussion.

A75 without preamp?
A75 without preamp?
Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Thread Tools Search this Thread
Old 20th January 2002, 09:32 PM   #1
SteveG is offline SteveG  United States
Account Disabled
Join Date: Jan 2002
Location: Newton Falls, Ohio
Question A75 without preamp?

I am in the process of building an A75, and was wondering if I could use the output of my SACD player to drive the inputs directly (no preamp) with a passive attenuator in between. If so, how would I go about choosing the value?

SACD player output specsfrom owner's manual)
level: 2VRMS (at 50Kohm), minimum load- 10K

Since it is spec'd into a 50Kohm load, I was thinking of using a 100K pot. What do you think? I believe that the A75's input impedance in unbalanced mode is about 75K. I'm not sure how you go about determining the minimum impedance as seen by the output... is it the combination of the pot on the output paralleled with the amps input impedance?
When it is possible to connect this way, what is the point of using a preamp anyway (besides tone control)?
It dosen't make sense to me to build an active preamp, unless your amplifier is really demanding. Is there something that I'm missing here?
  Reply With Quote
Old 20th January 2002, 09:57 PM   #2
jam is offline jam  United States
diyAudio Member
jam's Avatar
Join Date: May 2001
Location: Auburn, CA, USA

I would choose a pot between 10k and 20k.
Cable length will be an important consideration. Keep the length of you interconnects as short as possible.

  Reply With Quote
Old 20th January 2002, 10:12 PM   #3
paulb is offline paulb  Canada
diyAudio Member
Join Date: Jun 2001
Location: Calgary
Assuming the sensitivity and impedance considerations are okay you don't require an active preamp. I prefer at least a buffer after the volume control but if you keep cables short it should be okay.
Many swear by passive preamps. Especially with a CD player, it shouldn't be a problem.
The impedance seen at the output of the CD player will be (at full volume) the parallel combination of the volume pot and the amp input impedance. At lower volumes, it will be higher until at zero volume it's just the pot.
  Reply With Quote
Old 21st January 2002, 02:34 AM   #4
audionut is offline audionut
diyAudio Member
Join Date: Jan 2002
Location: Cleveland ohio
A75 without preamp?
Default Aleph 3

I have built a number of Aleph 3 channels and use them in a Bi amped system...as in the Zen amps, I have been using air core 2mh inductors in the power supplies. I measure very low ripple on the Aleph rails, (20 mv), I wonder what other benefits there are to having these inductors in the Aleph power supplies. The inductors certainly reduced the hum in the Zens to almost nothing.
To my ears, the Aleph's are sweet and warm sounding.
  Reply With Quote


A75 without preamp?Hide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Tube Preamp Popping on Source Input Change (?) / 6DJ8 Preamp On Chip Amps Travis Clarke Tubes / Valves 3 16th October 2008 05:52 AM
Guitar Preamp = MIC Preamp = other preamp ,,are they all same? Paswa Instruments and Amps 1 12th March 2008 06:16 PM
twisted pear Preamp/other suggestions for Preamp kit LukeDuke Chip Amps 1 1st February 2008 10:57 PM
Electret mic preamp - will phono preamp work? darthmullet Analogue Source 6 12th October 2007 08:32 AM
wiring preamp outs on a preamp bonsai171 Solid State 4 22nd March 2004 11:13 PM

New To Site? Need Help?

All times are GMT. The time now is 12:36 AM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 16.67%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright ©1999-2017 diyAudio