update
I finished the new lay-out.
The couple caps are now 25mm x 40mm. To save space, all the small stuff has to be placed on the other side then the couple caps.
The TO-92 devices have now a slightly different package.
And it fits on a standard 160mm x 100mm pcb.
The components have the same numbering as the Aleph P 1.7 Service manual.
And a final question: What would better for the gain pot? A normal pot or just a simple adjust pot.
I finished the new lay-out.
The couple caps are now 25mm x 40mm. To save space, all the small stuff has to be placed on the other side then the couple caps.
The TO-92 devices have now a slightly different package.
And it fits on a standard 160mm x 100mm pcb.
The components have the same numbering as the Aleph P 1.7 Service manual.
And a final question: What would better for the gain pot? A normal pot or just a simple adjust pot.
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- Aleph P 1.7 pcb