lawbadman,
You will find details of the single ended operation in the original article.. http://www.passdiy.com/pdf/balzenpre.pdf
macka
You will find details of the single ended operation in the original article.. http://www.passdiy.com/pdf/balzenpre.pdf
macka
lawbadman said:Hi all
I am in the middle of building a bosoz pre amp, but I will only be using the + input and + output. My question is if the following parts are necessary for my application:
C1, R9, R11, R8, and R14.
You don't need C1, R9, and R11 for sure.
I left R8 and R14 on mine. I ended
up installing a balanced input on mine. Son of
Zen's bride does good work as a
balanced-to-single-ended converter.
Erik
I made a minor adjustment by using a
choke-input filter after the rectifiers.
I can't say for sure that it made a colossal
improvent, but the basic quality of the
remaining crud was more of a hum than a buzz.
I suppose the hum would have driven me
crazy(*) more slowly than a buzz would, but I
still couldn't tolerate it. Therefore I ended up
adding the zener/source-follower
"regulator" from the article (lower voltage,
though, naturally).
Now it is plenty quiet enough for my listening
room where the ambient noise level is rather
higher than I'd like.
Erik
(* Okay, it's not a drive; it's more of a short,
leisurely stroll. )
choke-input filter after the rectifiers.
I can't say for sure that it made a colossal
improvent, but the basic quality of the
remaining crud was more of a hum than a buzz.
I suppose the hum would have driven me
crazy(*) more slowly than a buzz would, but I
still couldn't tolerate it. Therefore I ended up
adding the zener/source-follower
"regulator" from the article (lower voltage,
though, naturally).
Now it is plenty quiet enough for my listening
room where the ambient noise level is rather
higher than I'd like.
Erik
(* Okay, it's not a drive; it's more of a short,
leisurely stroll. )
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.