hello there
I saw here few of you who use ICAR 50uf capacitors.I too want to order those caps 50MF SB25/R-FS-DECK - MULTICOMP - CONDENSATORE, 50UF, D-DECK STUD | Farnell Italia and i was wondering if they come with fixing system ?
I saw here few of you who use ICAR 50uf capacitors.I too want to order those caps 50MF SB25/R-FS-DECK - MULTICOMP - CONDENSATORE, 50UF, D-DECK STUD | Farnell Italia and i was wondering if they come with fixing system ?
The last time I bought studded caps they did'nt so you'll need some of these.
PYB7041 - KEMET - NYLON CAP NUT, M12 | Farnell United Kingdom
PYB7041 - KEMET - NYLON CAP NUT, M12 | Farnell United Kingdom
all motor runs I saw are having either screw fixed on bottom , or slot mounting for same
in both cases , screw is isolated from cap (electrodes) itself , what's completely logical - they're serious professional devices , not usual audio mumbojumbo thingie
in case that these (linked ) caps are having slot mounting screws , it's normal to expect that you'll get screws along with caps
in both cases , screw is isolated from cap (electrodes) itself , what's completely logical - they're serious professional devices , not usual audio mumbojumbo thingie
in case that these (linked ) caps are having slot mounting screws , it's normal to expect that you'll get screws along with caps
the special motor run caps are not stud mounted, are they ?
ahh, those in question are special 'lighting' caps
some plastic cased, some not
but all still appear to be 'dry caps' and with isolated can
are lighting caps good ?
hey, maybe they are the secret BlackGate caps
ahh, those in question are special 'lighting' caps
some plastic cased, some not
but all still appear to be 'dry caps' and with isolated can
are lighting caps good ?
hey, maybe they are the secret BlackGate caps
Motor-Runs !...........
.
Cheers.
Si.
ALL fully-insulated = No worries !!!
I hear motor-runs are hard to get, behind the Iron Curtain...
...mystery-buyer hoarding all available stocks...
...rumour has it; for Earth's LARGEST plastic PSU.
( I don't believe a word of it personaly...
...just another 'urban myth'...Mmmm...? )
.
Cheers.
Si.
ALL fully-insulated = No worries !!!
I hear motor-runs are hard to get, behind the Iron Curtain...
...mystery-buyer hoarding all available stocks...
...rumour has it; for Earth's LARGEST plastic PSU.
( I don't believe a word of it personaly...
...just another 'urban myth'...Mmmm...? )
Attachments
those black ones looks as motor start caps
nono in PSU , they're just bad electrolytics
Why are they a nono in a psu? And dose that include tube psu?
When you say bad.... Bad how?
Poorly made?
Don't last long?
Lower than spec?
Thanks for info.
RIFA PEH 200 has the stud screw tied to the cathode. That yields to a short circuit in the negative side of a +/- power supply if you connect it to PE of the chassis, how it is usually mounted. This will fry a diode bridge until break it in two. Lot's of smoke and cracks. I promise!
Pointing it out on the datasheet LOUD and clear? That's for sissies!
Datasheet & application note database, pdf, circuits, cross reference, data sheet, datasheets | Datasheet Archive
Pointing it out on the datasheet LOUD and clear? That's for sissies!
Datasheet & application note database, pdf, circuits, cross reference, data sheet, datasheets | Datasheet Archive
- Home
- Amplifiers
- Pass Labs
- Pictures of your diy Pass amplifier