On my Aleph-Ono-Prototype i have directly
connected the powercable on the Aleph Ono-Boards and i am not satisfied with this solution. On the PCB-Board i am using Print-Connectors with Pins in 5 mm Distance. This was possible due that the drill-holes on the PCB-Boards from Pquadrat are big enough. Unfortunaly on the Ono-PCBs the distance is 7 mm and the holes are smaller. So its not possible to use Print-Connectors with 5 mm Raster-
distance. I think of this Part from RS-Componente with 7,62 mm dimensions
Part-Number 189-5966 and for the output
connections Part-Number 189-5972.
I hope i can make the pins a little bit smaller, so that it fits in the drill-holes of the Ono-PCBs ?
connected the powercable on the Aleph Ono-Boards and i am not satisfied with this solution. On the PCB-Board i am using Print-Connectors with Pins in 5 mm Distance. This was possible due that the drill-holes on the PCB-Boards from Pquadrat are big enough. Unfortunaly on the Ono-PCBs the distance is 7 mm and the holes are smaller. So its not possible to use Print-Connectors with 5 mm Raster-
distance. I think of this Part from RS-Componente with 7,62 mm dimensions
Part-Number 189-5966 and for the output
connections Part-Number 189-5972.
I hope i can make the pins a little bit smaller, so that it fits in the drill-holes of the Ono-PCBs ?