Forte model 40 phono stage fault

[cc1961]

Hello folks,
i am new to this diyaudio, forgive me if this is not the correct procedure,
currently i am trying to find a fault in my Forte model 40 phono stage it plays
for a while then powers off for a few seconds then comes back on.
have looked for dry solder joints etc, anyone come across this type of fault before.

regards,
Craig

 

[Nelson Pass]

Sounds like a supply fault. I would monitor the DC
rail voltages on the supply - as I recall, if the rails fall too
low, the relays open.

 

[cc1961]

Thank you, i will check voltages, the main relay is not opening when phono stage cuts out. I would really be gratefull if you could supply copy of manual or circuit diagram.

regards,
Craig