|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Pass Labs This forum is dedicated to Pass Labs discussion. |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
1st July 2008, 08:11 PM
|
#1 |
|
diyAudio Member
Join Date: Jan 2007
|
Bride of Zen - AudioExpress PCB - Help
I am buildling BOZ using audioexpress pcb but i have some doubts. I apologize in advance if these question are obvious.
(1) TIP and 610 installation on the board are not obvious as both transistors are 3 pins. The boards are 2 pin + thru-hole. I understand that using thru-hole with connect drain but what do you do with actual pin 2 on the device (i.e. cut it off)? (2) What is the correct kind of heatsink required for this application (i.e. Q1, Q101, Q201)? Thanks in advance for your help. Pathmark |
|
|
1st July 2008, 08:30 PM
|
#2 |
|
diyAudio Member
Join Date: Jul 2001
Location: The Netherlands
|
I used a bolt&nut&washer to fasten the small heat sink to the transistor... that way the 3rd pin is connected , through the bolt, to the housing of the trannie to the PCB track..
The heatsink must be U-shaped, about as big as your thump... goodluck, Thijs |
|
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New PCB for bride of zen | maartentje | Pass Labs | 6 | 28th February 2005 07:19 AM |
| Bride of zen PCB | maartentje | Pass Labs | 8 | 14th February 2005 01:26 AM |
| bjt bride of zen | renjiish | Pass Labs | 1 | 24th September 2004 03:54 PM |
| Bride of Zen, Bride of Son of Zen | 2Bak | Pass Labs | 4 | 12th May 2002 04:51 PM |
| Bride of Son of Zen vs. A;eph P | Peter Daniel | Pass Labs | 0 | 25th January 2002 07:45 PM |
| New To Site? | Need Help? |
