First Watt F1 Pcb
 

Hi i'm max!

i have a question....and a problem at the same time.

there's a place in the world ........where i can buy the PCB's for the First Watt F1 amplifier?

thanks!!!!!!

max

:smash: :smash:

Consider asking this question in the Pass section of this forum... you may get a better response.

moved

F1 Power Supply Clone,
 

F1 Power Supply Clone,
Check image file attached.

email me, for details.

suds

First Watt F1 PCB Clone
 

Hi,

I have made PCB from schematic.
Both Power Supply and Amp Boards are ready.

There is difference in size & components size (resistors / Pot )

e-mail me, for further details, I will mail you pdf or PS Board and AMP board.

(Attached is image of AMP Board)

F1 Board Prototype tested
 

hello all..


F1 Board prototype is ready, working fine .

Now that I have a working F1 Amplifier.... Observed the following...
(I did not put Heat sink.)

MOSFET becomes Very very Hot.. (Q3 and Q4 Smokes with out heat sink)
Thick Heat sink with silicon paste and insulation is required.

Quality of sound is very good.. !

Instead of ztx550, BC557 is used.

Are PCB Available ?
 

Hi,

I don't see any further posts on PCB.

Are they available.. ?
I am making PCB for myself, I don't mind making few more. !!! But there is no match for Origal PCB's!.

Acaudio made a nice pdf for home-etching :
http://www.acaudio.de/

Hi Hife,

If not too late I'm interested in 2 x amp and 1 x psu boards.

Cheers,
Morten

Hii
 

Hi,,

I have not yet started working on it,

I am making this for my own use, I dont want to go against copyright etc.

I want to hear from author, owners also.

these are hand made, chemical etched PCB.
just sharing my PCB,


helfred I am not able to mail you, you e-mail me ( Still Under moderation) don't know why ???

Thanks