|Parts Where to get, and how to make the best bits. PCB's, caps, transformers, etc.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|16th February 2007, 07:41 PM||#1|
Join Date: Feb 2007
Location: in front of my laptop
Terminating Sennheiser HMD 280 Pro
Hello, new to this forum but it seems the right place to ask help for my problem...
I just purchased a Sennheiser HMD 280 Pro Headset and it is un-terminated. (no jacks and loose wire ends)
the cable ends as follows:
----- red (+)
----- blu (-)
----- wht (+)
----- blk (-)
now it is my understanding that these will connect to a 1/8" stereo jack. i am not clear because i have 3 connectors on the jack but 4 wires...
additionally, it has 3 more wires labeled
--- yellow (+)
--- green (-)
i believe this i connect to my mic jack which is mono, right?
any thoughts on how to connect this to a jack?
thank you in advance for your help.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Re-terminating a XLR cable with RCA connectors||fatwok||Parts||9||14th February 2009 11:50 PM|
|8" run in chassis before terminating SPDIF Signal... 75R Resistor Placement||PaulHilgeman||Parts||14||30th August 2008 02:16 AM|
|Terminating a coaxial (isolated) interconnect||Alves||Everything Else||3||7th December 2005 10:08 AM|
|Sennheiser Mic||george a||Everything Else||1||27th April 2005 12:43 AM|
|terminating unused parts of multichannel opamps||matjans||Chip Amps||1||2nd June 2004 10:39 PM|
|New To Site?||Need Help?|