I want to use Mills non inductive wirewound resistors on a DAC and tube stage PCBs. The throughholes are spaced about 1/2" (12.5mm) but the resistor body is 0.625" (16mm). Can I bend the leads back underneath the resistor to fit through the holes, or is this a bad idea...and hence be looking for a smaller part?
Use of resistors are for I/V conversion and high frequency filter in signal path.
Use of resistors are for I/V conversion and high frequency filter in signal path.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.