On most of the SMD electro's i've seen like that,there has been a little plastic spacer on the bottom,with a "notch" cut into one side-I *think* the positive lead,but i'm not sure.(correct me if i'm wrong)
If the plastic spacers are still on the board(being held on by the pins?),you could probably figure out which pin is which.
Edit: In the above pic (if you look close) the plastic spacer bit has the corners rounded off under the (+) terminal.
If the plastic spacers are still on the board(being held on by the pins?),you could probably figure out which pin is which.
Edit: In the above pic (if you look close) the plastic spacer bit has the corners rounded off under the (+) terminal.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.