Need help for making a brigde or buying one somewhere.
Acoustic G100 gitar amplifier (4x6550 3x ecc 83 1x ecc 81) uses four diodes 1n4007 in a square soldered in series for rectifying.
Current is unstable though so needs replacement
Four freds would do or a bridge if existing ..
Are the Freds as easy to solder on to each other as these 1n4007 or is that all different
Where to get these.
Max29
Acoustic G100 gitar amplifier (4x6550 3x ecc 83 1x ecc 81) uses four diodes 1n4007 in a square soldered in series for rectifying.
Current is unstable though so needs replacement
Four freds would do or a bridge if existing ..
Are the Freds as easy to solder on to each other as these 1n4007 or is that all different
Where to get these.
Max29
I have soldered right to the pins on my projects. I bend the end of the lead over it self, form an eye with the wire to be joined and then I put them together and solder. The hole thing gets finished off with shrink wrap around the solder joints.
Be sure to use a BIG heat sink as this method takes lots of heat to get a good joint. I find a surgical clamp or small locking pliers work well
Hope this helps. You can see my project at http://www.diyaudio.com/forums/showthread.php?s=&threadid=68506
Be sure to use a BIG heat sink as this method takes lots of heat to get a good joint. I find a surgical clamp or small locking pliers work well
Hope this helps. You can see my project at http://www.diyaudio.com/forums/showthread.php?s=&threadid=68506
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.