The volume pot on my amp (EAR859 13w SET) is getting a bit noisy so I thought I'd change it for a stepped attenuator. According to the schematics it is a 4k7 log.
So far I haven't been able to track any down. So how could I accomodate a different value without causing a loss of sound volume?
Cheers
Lilolee
So far I haven't been able to track any down. So how could I accomodate a different value without causing a loss of sound volume?
Cheers
Lilolee
Here's the schematic
http://www.leehibbert.pwp.blueyonder.co.uk/ear859.jpg
It definately says 4k7 log.
BTW any advice about what components to change and where to put the bypass caps.
Thanks a huge amount
Lilolee
http://www.leehibbert.pwp.blueyonder.co.uk/ear859.jpg
It definately says 4k7 log.
BTW any advice about what components to change and where to put the bypass caps.
Thanks a huge amount
Lilolee
Theirs another (cleaner) schematic listing 4k7 at
http://joelist.free.fr/schematics/Thorsten collected oddities/
Is the value that critical?
Regards
James
http://joelist.free.fr/schematics/Thorsten collected oddities/
Is the value that critical?
Regards
James
No, the value of the pot isn't that critical, but...
Keep in mind that your source is going to see a 4.7k load. That's pretty low, and some phono stages, tape decks, CD's etc. may have a hard time with it. I regard even 10-20k as on the low side for input impedance. 47k is a good compromise, although many pieces use 100k, or even 1M.
If you're using a source whose output is capacitor-coupled, you're almost certainly getting a *very* high rolloff in the bass.
Really, the only reason to have an input resistor that low is to reduce cable-related sonic problems. I'll leave that one up to you.
By all means, change values if you like. At that point in the circuit, there's plenty of lattitude. (Or leave it the same, if you want...)
Grey
Keep in mind that your source is going to see a 4.7k load. That's pretty low, and some phono stages, tape decks, CD's etc. may have a hard time with it. I regard even 10-20k as on the low side for input impedance. 47k is a good compromise, although many pieces use 100k, or even 1M.
If you're using a source whose output is capacitor-coupled, you're almost certainly getting a *very* high rolloff in the bass.
Really, the only reason to have an input resistor that low is to reduce cable-related sonic problems. I'll leave that one up to you.
By all means, change values if you like. At that point in the circuit, there's plenty of lattitude. (Or leave it the same, if you want...)
Grey
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Design & Build
- Parts
- New Volume Pot