Hi to all,
Did any of you build the 1PPM IM Distortion Analyser from Richard Crawford ?
I have assembled it with the PCBC-6 from AudioXpress and I would like to
precise a few points:
1)- I would like to know the values of R108 and R123, as they are not specified ?
2)- On the schematic Figure 5: R126 is 4420 Ohms on DC Output.
3)- Figure 13: a cap C2... under U102 is : 0.1µF and should be labeled C2x
Thanks.
Best regards.
Alain.
Did any of you build the 1PPM IM Distortion Analyser from Richard Crawford ?
I have assembled it with the PCBC-6 from AudioXpress and I would like to
precise a few points:
1)- I would like to know the values of R108 and R123, as they are not specified ?
2)- On the schematic Figure 5: R126 is 4420 Ohms on DC Output.
3)- Figure 13: a cap C2... under U102 is : 0.1µF and should be labeled C2x
Thanks.
Best regards.
Alain.
Hello Alain!
Try this it directly answers some of your questions.
http://www.audioxpress.com/magsdirx/aX/addenda/distortion .pdf
Mark
Try this it directly answers some of your questions.
http://www.audioxpress.com/magsdirx/aX/addenda/distortion .pdf
Mark
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.