For Adcom 5400 power amp-need speaker binding posts

[DaveFri]

Would anyone know what kind(size,where to get,etc)speaker binding posts? I had received 2 from China but they were too small.....on the Adcom the posts are quite a bit bigger...any help appreciated !!

Thx,Dave

 

[rayma]

Would anyone know what kind(size,where to get,etc)speaker binding posts? I had received
2 from China but they were too small.....on the Adcom the posts are quite a bit bigger.

Can you post photos of your Adcom posts, and the holes they mount in?

 

[DaveFri]

This is the type II amp.The speaker posts are on little black plastic standoff's...inside and out of cabinet'
Adcom 5400 photos - Google Search

 

[audiopro]

Common 3/4 inch center binding posts. The insulator probably has 1/2 hole. Go to Mouser Electronics.
You'll find them there.

 

[DaveFri]

hmmmm......doing searches...can't seem to find them....i am not really sure of the correct verbage to use for a search

 

[MAAC0]

What about fitting Speakon connectors ?

 

[DaveFri]

this is what i found.I think this is the same size as what i got from China

An externally hosted image should be here but it was not working when we last tested it.

 

[DaveFri]

that may not have went thru...try againhttp://www.mouser.com/ds/2/159/2417073_6883_6884-58686.pdf


The ones i received are definitely smaller than what is on the amp!!

 

[DaveFri]

OK.....yes.....it is 3/4" center but the ones on the amp are longer and much beefier...

 

[rayma]

OK.....yes.....it is 3/4" center but the ones on the amp are longer and much beefier...

There likely are two round holes 3/4'' apart, but you still need to know the hole diameter to find replacements that will fit.
There are many brands, and the ones on the amp may no longer be available. The style with a base is for antirotation,
like these have. BP21-2RRN-BPKG-SUPERIOR ELECTRIC-Datasheet