I need to locate a part from a Huntington Guitar Amplifier GA 10 (MFG parts # AMP-G10).
I am looking for the input connector. It has 5 pins that fit onto the pc board. It houses a quarter inch jack input when the guitar chord is plugged into the amp.
There is no part number on the connector. It is made in China.
I can provide photos of the part I wish to replace. It has a crack in it. Thanks!
I am looking for the input connector. It has 5 pins that fit onto the pc board. It houses a quarter inch jack input when the guitar chord is plugged into the amp.
There is no part number on the connector. It is made in China.
I can provide photos of the part I wish to replace. It has a crack in it. Thanks!
Attachments
Are any of the pins in the four by the corner left unused? Because I sure would be grabbing one of these fender jacks from my drawer to see.
Jack - Input, Original Fender® 1/4", 4 Pin, Mono | Antique Electronic Supply
If you DO need all four, then snip the extra legs off this one:
Jack - Stereo, 9 Pin, PC Mount, Original Fender, Amps '88-'99 | Antique Electronic Supply
Jack - Input, Original Fender® 1/4", 4 Pin, Mono | Antique Electronic Supply
An externally hosted image should be here but it was not working when we last tested it.
If you DO need all four, then snip the extra legs off this one:
Jack - Stereo, 9 Pin, PC Mount, Original Fender, Amps '88-'99 | Antique Electronic Supply
An externally hosted image should be here but it was not working when we last tested it.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.