diyAudio (
-   Parts (
-   -   Cable shield grounding (

Prune 3rd December 2003 05:33 AM

Cable shield grounding
I read in a number of places to ground the calbe shield at the source end rather than the amp. My question is, though wouldn't that send interference into the more sensitive component?

RIC 20th December 2003 01:28 AM

I've been doing this for some time now with my guitar cords, and work's fine. I use two conducter mic cable, one conducter is hot / signal, the other is ground, both end's. and the shield is only at
signal end. from what I recall, it prevents signal loss for one. plus a cleaner signal path / loop. maybe as in signal phase?
anyway the trick is too get the shield in the plug, ect... housing
but not touching ground.
most likely you know all this and it's probably e-realavent to your ?

All times are GMT. The time now is 04:40 PM.

vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999-2017 diyAudio

Content Relevant URLs by vBSEO 3.3.2