??repairable??

[fabricated]

Anyone else ever come across this problem? Is it possible to resolder the tab on or should i try and get another one? I have 5 other ones and was hoping to salvage this one for another project.

 

[GloBug]

When it comes to lytics it's nice to know you have a fresh intact part.

Heat would be a concern but give it a try. I don't know if the "snap-ins" are more sensitive or not to heat.

Clean the parts well first to minimize soldering time. Acid flux would do it, but would have to be completely cleaned afterwards.

 

[fabricated]

do you think it would be a bad idea to clean it completely and solder on a 8/32 nut to use it with a cut down machine screw?

 

[KatieandDad]

It depends on what the connector pole is made from ?

You might be able to drill and tap the pole piece.

I'd replace it personally. If it's aesthitically important then gut it and use the body as a cover for the replacement part.

 

[fabricated]

I'd replace it personally. If it's aesthitically important then gut it and use the body as a cover for the replacement part.

Not that important just was trying to save it is all..... they were given to me so i don"t know who makes it