diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Parts (http://www.diyaudio.com/forums/parts/)
-   -   Magnavox CDB 650 Tray Drive Belt Replacement (http://www.diyaudio.com/forums/parts/178701-magnavox-cdb-650-tray-drive-belt-replacement.html)

searchlight 7th December 2010 09:51 PM

Magnavox CDB 650 Tray Drive Belt Replacement
 
I inherited a Magnavox CDB 650 without a belt. Has anyone ever replaced theirs, and know the proper length for the replacement.

It seems to be less than 2 inches by observation from the small pulley to the large Drive Wheel but this is guesstimate.

Thanks.

indianajo 8th December 2010 03:48 PM

Well I don't know what a CDB 650 is, but if the belt is under 2" long, I tend to use rubber O-rings. The hardware store will have an assortment at $.10 each. If you find the right length but want a square cross section, mcmaster.com sells bags of 100 o-rings of round or square cross section. You can measure by looping a string around it and marking the crossing point with a sharpie or felt marker.

DreadPirate 8th December 2010 11:01 PM

Take some measurements and order a few in and around your measurements (a bit smaller, they tend to stretch) from mcm electronics.

Enzo 10th December 2010 06:21 AM

Wrap a piece of string around the belt path, then measure the resulting loop. Then take Pirate's advice.


All times are GMT. The time now is 08:35 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2