Greetings everyone,
If my power supply is located two or so feet from the amplifier, should I use shielded cable for the bias voltage? The filament supply will be located in a separate cable assembly from the "DC" supplies and all cabling will be done with teflon coated wire.
Thanks,
Ray
If my power supply is located two or so feet from the amplifier, should I use shielded cable for the bias voltage? The filament supply will be located in a separate cable assembly from the "DC" supplies and all cabling will be done with teflon coated wire.
Thanks,
Ray
No, just decouple it to ground near the valves.
Confirmed..
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.