Strange resistor

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I have found these resistors on a Japanese PCB from a high tech monitor.
Never saw them before, does someone know their quality ?
They are non magnetic, have about 5% tolerance and where used in the video circuits extensively.
A picture of some of them, compared to a normal 1/4W resistor :
 

Attachments

  • mvc-004.jpg
    mvc-004.jpg
    25.5 KB · Views: 388
djmiddelkoop:

I haven't used the Nikkos all that extensively, so I shouldn't comment. I did use the Susumus off and on, and these were quite reasonable, I felt. These were touted as being both low-noise and low-inductance. Measured distortion was also somewhat lower than average for a metal-film. _If_ the Nikkos are similar to the Susumus, then there should be no problem with using them.

Not needing to form the leads makes life easier during the building process. :)

hth, jonathan carr
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.