Pilot lamp for Technics SE-A900S Vu meters

[FE3T]

I just recived a Technics SE-A900S Power amp in good condition
But some of the pilot lamps for the vu meters are burnt out.
The part number from Panasonic are XAMR131, but now i have discovered that Panasonic has stopped selling these.

Can anyone point me in the direction of a suitable replacement?

Measuring the voltage over each lamp gives about 7-8volts (measured on an identical amp with ok lamps) and the distance betwin the holes on the print are 24mm

 

[rrrremus]

Problem solved ?

have you replaced the lamps in the mena time ?
I have a few spares.

 

[Diginerd]

It's not an exact like for like replacement, but in the past I've fixed other vu meters by embossing a white LEDs in some white sealant above or either side of the plastic case.

The trade off is the light is not so warm as with a lamp, but you'll never have to replace it again.

 

[Enzo]

Various suppliers carry "meter lamps." small glass tubes with axial leads. I keep them onhand in three voltages.

 

[stoc005]

Try a model railroad shop

They have 12 volt leaded bulbs called grain of wheat bulbs. Will work if you need 12v bulb. Might have other voltages too.

 

[krajnc]

www.bleken.no

 

[kay110]

XAMR131 bulb/lamp - Suitable for Technics equipment [XAMR131] - £1.44 : Electronic Repair Centre Ltd