diyAudio (
-   Parts (
-   -   Pilot lamp for Technics SE-A900S Vu meters (

FE3T 2nd February 2009 11:43 AM

Pilot lamp for Technics SE-A900S Vu meters
I just recived a Technics SE-A900S Power amp in good condition
But some of the pilot lamps for the vu meters are burnt out.
The part number from Panasonic are XAMR131, but now i have discovered that Panasonic has stopped selling these.

Can anyone point me in the direction of a suitable replacement?

Measuring the voltage over each lamp gives about 7-8volts (measured on an identical amp with ok lamps) and the distance betwin the holes on the print are 24mm

rrrremus 4th August 2010 08:20 AM

Problem solved ?
have you replaced the lamps in the mena time ?
I have a few spares.

Diginerd 4th August 2010 09:30 AM

It's not an exact like for like replacement, but in the past I've fixed other vu meters by embossing a white LEDs in some white sealant above or either side of the plastic case.

The trade off is the light is not so warm as with a lamp, but you'll never have to replace it again.

Enzo 5th August 2010 01:37 AM

Various suppliers carry "meter lamps." small glass tubes with axial leads. I keep them onhand in three voltages.

stoc005 5th August 2010 01:44 AM

Try a model railroad shop
They have 12 volt leaded bulbs called grain of wheat bulbs. Will work if you need 12v bulb. Might have other voltages too.

krajnc 5th August 2010 09:14 PM

kay110 20th January 2013 08:54 AM

XAMR131 bulb/lamp - Suitable for Technics equipment [XAMR131] - 1.44 : Electronic Repair Centre Ltd

All times are GMT. The time now is 03:53 PM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 18.75%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Copyright ©1999-2018 diyAudio