Does anyone know where to get transformer mounting braces like these to replace end bells? I am trying to move a transformer inside a chassis.
An externally hosted image should be here but it was not working when we last tested it.
Geek said:Don't forget to insulate them from the screws, lest you end up with a "shorted turn".
Yup. And you can get nice nylon sholder bushings from McMaster.com on catalog page 3180.
dsav,
Why not just keep the endbells? I have Mikey making me a pair of EL34 outputs which will go in Zerocase cans for the cuteness, and so I specified bracket mount. He just today posted me back saying, 'Sonofagun, the four brackets are more expensive than endbells!' I told him to nemmine, just put the endbells on there. The VT4C Tonyaba choke I want to use was real close to not fitting inside the can, so I just put a cutoff wheel on the Dremel and cut about half the 'bell' part off, 'till it was a little shy of the winding. Free brackets.
Aloha,
Poinz
Why not just keep the endbells? I have Mikey making me a pair of EL34 outputs which will go in Zerocase cans for the cuteness, and so I specified bracket mount. He just today posted me back saying, 'Sonofagun, the four brackets are more expensive than endbells!' I told him to nemmine, just put the endbells on there. The VT4C Tonyaba choke I want to use was real close to not fitting inside the can, so I just put a cutoff wheel on the Dremel and cut about half the 'bell' part off, 'till it was a little shy of the winding. Free brackets.
Aloha,
Poinz
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.