That 15band EQ won't be of much use for feedback control only general response shaping but otherwise this can work.
You will need a Y cable to split the monitor out signal from the mixer to both inputs on the EQ, then connect the L output of the EQ to input 1 of the first amp and R output of the EQ to input 1 of the second amp. Now go into the setup menues of each amp and set them for Y input, that sends the signal from input 1 to both amplifier channels. Connect the speakers to L and R outputs on both amps.
You will need a Y cable to split the monitor out signal from the mixer to both inputs on the EQ, then connect the L output of the EQ to input 1 of the first amp and R output of the EQ to input 1 of the second amp. Now go into the setup menues of each amp and set them for Y input, that sends the signal from input 1 to both amplifier channels. Connect the speakers to L and R outputs on both amps.
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.