|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Multi-Way Conventional loudspeakers with crossovers |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
29th March 2007, 05:34 PM
|
#1 |
|
diyAudio Member
Join Date: Nov 2002
Location: Hungary
|
AudioTester 2.2 Calibration
Hi!
I have the AudioTester 2.2 and after a couple of hour I could make some impedance and TS parameter measurements. Every thing is fine and the results was very near to a reference professional made measurement. But! I am not 100% sure that I understand well the calibration process. Could somebody help me and to tell me what and where I need to adjust? In the manual it is a bit "dim" where and which pot I need to adjust in the windows mixer. Play or record mixer? Master volume or input line volume etc. I use SB LIVE 5.1 sound card and it can drive the speaker very well. Now I have 549mV output voltage and full open input volume. One more question: what is the best value for the serial resistor? 10 or 33 Ohm?? Now I use 21 Ohm...... Greets: Tyimo |
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Audiotester + M-audio - info + question | pmillett | Tubes / Valves | 24 | 29th June 2008 04:19 PM |
| E-mu 0202 + audiotester | dave slagle | Tubes / Valves | 18 | 28th June 2008 01:28 PM |
| Amp Calibration in SW | arc2v | Multi-Way | 7 | 29th February 2008 06:38 PM |
| Hellp with AudioTester 2.1 | a007udio | Multi-Way | 6 | 24th March 2007 12:26 PM |
| New To Site? | Need Help? |
