All my JustMLS impedance readings are 1 ohm too high.
Attached is the impedance calibration file. Both signals line up perfectly.
But when I test resistors they all read approx 1 ohm higher than their true value, which I've checked with my meter.
My test setup is exactly as specified in the JustMLS manual.
Anyone suffered from this problem? Any clues?
Attached is the impedance calibration file. Both signals line up perfectly.
But when I test resistors they all read approx 1 ohm higher than their true value, which I've checked with my meter.
My test setup is exactly as specified in the JustMLS manual.
Anyone suffered from this problem? Any clues?