This was originally posted over in "Musical Instruments," but I am not sure that is its home. Perhaps here of "Full Range?"
I have a pair of drivers with the following T/S numbers as supplied by Eden for their 10" drivers (thank you Eden):
Fs = 43Hz
Znom = 4 ohm
Re = 2.2 ohm
Qts = 0.16
Qms = 3.26
Qes = 0.17
SPL = 97 dB/W
Sd = 0.034 m^2
BL = 10.08 T-M
Le = 9.2 E-04 H
Vas = 2.75 ft^3
What the Eden cabs look like/spec as and what I come up as a start in WiniSD do not match. What should I be looking at for a single driver enclosure?
I will be adding a tweeter for extension, which will also resolve my requirement for 8 ohm loads. This will end up being a pair of small cabs (I hope) for portability...and closet-ability as not to clutter the family room with gear.
Thanks!
I have a pair of drivers with the following T/S numbers as supplied by Eden for their 10" drivers (thank you Eden):
Fs = 43Hz
Znom = 4 ohm
Re = 2.2 ohm
Qts = 0.16
Qms = 3.26
Qes = 0.17
SPL = 97 dB/W
Sd = 0.034 m^2
BL = 10.08 T-M
Le = 9.2 E-04 H
Vas = 2.75 ft^3
What the Eden cabs look like/spec as and what I come up as a start in WiniSD do not match. What should I be looking at for a single driver enclosure?
I will be adding a tweeter for extension, which will also resolve my requirement for 8 ohm loads. This will end up being a pair of small cabs (I hope) for portability...and closet-ability as not to clutter the family room with gear.
Thanks!