Crossover Resistors.. Advice Needed

[gilbert-]

Hello,

I have the following crossover to build for a MTM TL using the Vifa p17/d25 combo however I am having trouble sourcing the necessary resistors. All parts have been obtained apart from these.

I can obtain resistors that are close to the reccommended values locally - if I use these following values for some of the resistors, what effect would this have on the crossover?

R3 changes from 20.0ohm --> 22.0ohm
R8 changes from 0.30ohm --> 0.27ohm
R13 changes from 25.0ohm --> 27.0 ohm


As you can tell, I am a novice when it comes to crossover designs. All credit goes to Zaph for the crossover design

Thankyou, any help would be very much appreciated.

Phillip

[sreten]

Hi,

R8 is not real, its the DCR of the inductor, same for R1 and R11.

R3 - Add a 220R 1 watt resistor in parallel with 22R to give 20R.
(This is probably not necessary as it won't make much difference)

R13 should be fine as 27R instead of 25R.

/sreten.

[gilbert-]

Alright, thankyou very much for your reply sreten.

I will do as you suggested.

Thanks again,

Phillip