Any PHY-HP KM 30 SAG DIY designs?

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I have been reading alot about the performance of these drivers. It seems they would be a great match(impedance and sensitivity) for my Atma-Sphere M60-Mk3's. I may even need to pull a tube or 2 to reduce it's power output. The manufacturer recommends an open baffle with adjustable unequal length wings, or a small enclosure with adjustable tuning on the rear wall(mini kit 30). Below is a link to the manufacturers site with their designs. Does anyone have a DIY design they would care to share that worked well for them? Is the coax version the way to go, or is there a benefit in going with the separate tweeter?
Thanks, James


http://www.phy-hp.com/English/Communication_E/Communication_E.html
 
Check out these designs. I can't remember where I found them. I am also looking to build some speakers useing the PHY-HP drivers.
 

Attachments

  • img_0234.jpg
    img_0234.jpg
    27.7 KB · Views: 441
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.