diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Multi-Way (http://www.diyaudio.com/forums/multi-way/)
-   -   Impedance compensation (http://www.diyaudio.com/forums/multi-way/79158-impedance-compensation.html)

DR ANALOGUE 7th May 2006 04:07 PM

Impedance compensation
 
2 Attachment(s)
Hello,

As I am developing a frequency crossover for the first time I am not sure which deviation of impedance is acceptable.

I enclosed the measured graph: The red line shows the compensated impedance. Blue, without compensation.

Firstly I would like to know if the minimum at 34Hz is a problem. The x-over frequency hould be around 250Hz-300Hz. I tried to modify the LCR, but the bump at 34Hz can not be avoided without causing a problem higher or lower.

Secondly, I damped the resonance of the cabinet. Still there is a slight inconsistency at 170Hz. Does this cause problems?

Thanks for your answer!!!


Kind Regards
Michael

richie00boy 7th May 2006 04:51 PM

It looks OK to me. I would not worry about compensating the lower impedance, it only matters around the crossover frequency.

Try to use PNG format for line images in future, it compresses almost as much as JPG but doesn't create the nasty artefacts.


All times are GMT. The time now is 12:29 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2