I downloaded the Soundeasy 10 Manual, and found the U and H baffle support. Does it also support "flat" open baffles?
I know if I made the wings very small on a U baffle it would probably work. I was just looking for confirmation before I purchased it.
I have an open baffle project in the works, and was hoping I could use the software to save a lot of MDF trees.
Comments welcome.
Doug
I know if I made the wings very small on a U baffle it would probably work. I was just looking for confirmation before I purchased it.
I have an open baffle project in the works, and was hoping I could use the software to save a lot of MDF trees.
Comments welcome.
Doug
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.