Parameters:
Qes = 0,364
Qms = 3,03
Qts = 0,325
Pe = 120W
dia = 12"
SPL = 90dB
Re = 6,7 ohms
Z = 8 ohms
Mms = 38,4 g
Hcoil = 17mm
Hgap = 7mm
Fs = 27Hz
Bl = 13,5 Tm
Sd = 0,0531 m^2
Vas = 260 l
Xlim = +/-13mm
I have access to this pretty cheap speakers, and want to make subwoofer which goes really deep. I want response from 20 to not higher than 60 Hz.
What box would you recommend ?
Will I get less distortion if I put the drivers in push-pull configuration ?
Thanks !
Qes = 0,364
Qms = 3,03
Qts = 0,325
Pe = 120W
dia = 12"
SPL = 90dB
Re = 6,7 ohms
Z = 8 ohms
Mms = 38,4 g
Hcoil = 17mm
Hgap = 7mm
Fs = 27Hz
Bl = 13,5 Tm
Sd = 0,0531 m^2
Vas = 260 l
Xlim = +/-13mm
I have access to this pretty cheap speakers, and want to make subwoofer which goes really deep. I want response from 20 to not higher than 60 Hz.
What box would you recommend ?
Will I get less distortion if I put the drivers in push-pull configuration ?
Thanks !
The best you can hope for here is an F3 at 35Hz from a 4.5 cu ft VB tuned at 33 Hz. Almost any driver that you want to run strong to 20 Hz will have to start off with an Fs lower than that.
The exception is a horn-loaded cabinet, which this driver could take down to 20 Hz no problem. Got room for a 14 foot horn?
The exception is a horn-loaded cabinet, which this driver could take down to 20 Hz no problem. Got room for a 14 foot horn?
Do you have two?
Take a look at this coffee table horn (click 'plans' they are free)
http://www.decware.com/newsite/mainmenu.htm
Groovy?
Craig
Take a look at this coffee table horn (click 'plans' they are free)
http://www.decware.com/newsite/mainmenu.htm
Groovy?
Craig
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.