Hi All
I'm after any information / design of this sub enclosure.
These where producted by Australia Monitor in the earily 90's and were loaded with PAS drivers.
To my knowledge these cabnets are no longer produced as the manufacture was brought out some time back.
If I can't find any info what software packages can I use to simulate and design the one myself using the rough dimension shown.
pics and specs attached
Craig.
I'm after any information / design of this sub enclosure.
These where producted by Australia Monitor in the earily 90's and were loaded with PAS drivers.
To my knowledge these cabnets are no longer produced as the manufacture was brought out some time back.
If I can't find any info what software packages can I use to simulate and design the one myself using the rough dimension shown.
pics and specs attached
Craig.
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.